Pipe Sock™
The Pipe Sock™ system is a fiber-reinforced polymer designed to eliminate crevice corrosion problems caused by direct metal-to-metal contact. It consists of a pre-formed, size specific fiberglass wear pad and a specially formulated adhesive system that combines to form a resilient crevice corrosion solution. Additionally, it can withstand temperatures up to 250° F and provide complete fit-up integrity with the pipe, eliminating moisture penetration and condensation cavities.
Specifications techniques
Mechanical Properties
Attribute Tensile Strength
Method ASTM D 3039
Value 54,000 psi
Attribute Compression Strength
Method ASTM D 695
Value 28,500 psi
Attribute Barcol Hardness
Method ASTM D 2583
Value 53
Thermal Properties
Attribute Max Operating Temperature
Value 250° F (121 °C)
Attribute Application Temperature
Value 41 °F to 95° F (5 °C to 35 °C)
System Properties
Attribute Wear Pad Thickness
Value 0.25 inches (6.35 mm)
Attribue Shelf Life – Black Magic ™
Value 18 months
Installation
1. Remove Pipe from Support
Lift the corroded pipe off support or stanchion.
2. Surface Inspection and Preparation
Brush contact surface with a wire brush and lightly abrade with sandpaper to remove loose dirt and scale. Inspect the area and repair any anomalies, as required.
3. Apply Black Magic
Remove release liner from the PipeSock™ and apply Black Magic™adhesive to the inside of the PipeSock™.
4. Install PipeSock™ and Reposition Pipe
Carefully position the PipeSock™ on the pipe. Then, lower the pipe on to the support. Taper any excess material with a putty knife.